usercreep.F and usermat .F

- February 21, 2023 at 5:26 pm
  
  sobhanis
  Subscriber
  
  /Hi there
  
  I ama trying to use usercreep and usermat.f codes for the same solid body. but I can't see the creep stress for that body. Is it possible to use them as same time for a body?
- February 22, 2023 at 5:32 pm
  
  John Doyle
  Ansys Employee
  
  I am not aware of a documented limitation to this combination.
  Are you including 'RATE,on' in /SOLU before executing the SOLVE?
  If yes, does your usercreep.F work as expected when usermat.F is excluded?
- February 22, 2023 at 5:47 pm
  
  sobhanis
  Subscriber
  
  the point is i want to use usercreep and usermat at the same time but only usermat workes and i can't see usercreep results there . still with RATE,on it doesn't show anything there for creep.
- February 22, 2023 at 6:49 pm
  
  John Doyle
  Ansys Employee
  
  I just confirmed that this combination is actually not supported. We have no good way of iterating between creep and plasticity when they are both user routines.
  Section 4.22.2 of the Material Reference Guide documents the subroutine combinations that are supported.
  Sorry for the confusion.