We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › How to use script to run the cfile for creating k file? › Reply To: How to use script to run the cfile for creating k file?

September 21, 2022 at 8:53 pm
igandiko
Ansys Employee

Your setup is not correct. In stage1, you select cfile. ls-opt will replace parameters and copy this cfile as LsPrepostOpt.inp. LSPP will run LsPrepostOpt.inp and generate ls-dyna k file. Lets say this k file is model.k. 

Double click on the small box between Stage1 and LS-Dyna and define file transfer operation to copy model.k file from Stage1 directories to LS-Dyna directories as DynaOpt.inp. Just enter "model.k" as "source" and "DynaOpt.inp" as "destination". 

In LS-Dyna stage, don't select any input file. DynaOpt.inp will directly come from LSPP stage and your ls-dyna job script will have i= DynaOpt.inp to run this file.