We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Default contact auto detection off › Reply To: Default contact auto detection off

August 8, 2022 at 8:01 am
Surya Prakash
Ansys Employee

Hi @greg2835,

The contact auto-detection can be turned off in the workbench by going to file>options>mechanical>turning off auto-detection. Please refer to the image attached. Hope this helps.

 

Thanks,
Surya