We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › LS Dyna › it says FAILED MESH › Reply To: it says FAILED MESH

May 1, 2021 at 3:47 pm
Ram Gopisetti
Ansys Employee
Cn you post the image showing the problematic geometry and the mesh type used. However, based on the your query it is something to do with the geometry used might have small features such as cuts, fillets, chamfers or drafts etc. Try disabling the adaptive mesh and use smaller mesh size. But better suggestions can be made only if you able to post the problem.
Cheers, Ram