Error : Point in mesh was not found !

- May 11, 2022 at 9:25 am
  
  guessoum.anis
  Subscriber
  
  Hello,
  I am analyzing a specific motor using Maxwwell 2D Transient in AEDT 2021 R2, I set up the model manually, it's an IPM synchronous motor (see attached file). When I analyze it i keep getting this error :
  Maxwell2d solver, process solver2d error: Internal Solver Error: 'Point in mesh was not found! '. Please contact Ansys technical support.
  Any idea what might the problem be ?
  Regards,
  Anis
- May 16, 2022 at 3:50 pm
  
  Navya Chode
  Ansys Employee
  
  Can you try the following?
  Add a dummy band object between the band and stator airgap.
  Under in initial mesh setting, move the slider towards a more fine setting.
  IF this did not work, change the mesh Method to classic in the Initial mesh settings and check.
  
  Regards Navya
- May 17, 2022 at 11:23 am
  
  guessoum.anis
  Subscriber
  
  Hello,
  The 2nd an 3rd solutions worked, thank you :)
  Have a nice day
  Anis