Learning Forum

[roisincoveney]

The following message is displayed in the console

Note: zone-surface: cannot create surface from sliding interface zone.

Creating empty surface.

I am not sure if this is a graphics card issue. I am using a Radeon Pro WX3100 graphics card which is set to be the default graphics card.

[Rob]

It's a solver created boundary condition that's part of the non-conformal mesh you've created. It's for regions where the interface pair don't overlap. You can't display it, it's for the solver to use to store data.

[roisincoveney]

Okay, thanks for replying. That explains that message.
I am just wondering about the mesh on the actual model. Should that display in the set-up section, as it currently won't show the meshing in this section? It does appear in the mesh section but when I go into set up it shows the model without mesh. I just thought it might be a graphics card issue but maybe I am wrong about that.

[Rob]

When you open the solver there's a Display option, what are you seeing if you open that panel up? I think default is currently to display faces only, if you want to see all of the surface mesh too you also need to pick edges & all.