-
-
March 29, 2022 at 3:59 pmChincheduSubscriber
Hi, I'm using Ansys Student Version 2021 R2 and installed visual studio 2017 community, set the environment variables. I have written UDF for my problem and able to build and load successfully. But after running simulation I'm getting the same result with and without UDF. How to check whether my UDF is working properly or not.
March 29, 2022 at 4:04 pmRobForum ModeratorDid you hook it up?
March 29, 2022 at 4:28 pmChincheduSubscriberYes I did. I'm working on two phase evaporation/condensation model. I have written UDF for mass and energy source terms. And hooked mass source terms in respective phases and energy source term in mixture phase under cell zone conditions.
March 29, 2022 at 6:41 pmAmine Ben Hadj AliAnsys EmployeeAdd a couple of User Defined Cell memories to keep track of the returns.
Why aren't you working with multiphase dedicated mass transfer UDFs?
Viewing 3 reply threads- The topic ‘Is UDF working properly or not’ is closed to new replies.
Ansys Innovation SpaceTrending discussions- Non-Intersected faces found for matching interface periodic-walls
- Unburnt Hydrocarbons contour in ANSYS FORTE for sector mesh
- Help: About the expression of turbulent viscosity in Realizable k-e model
- Cyclone (Stairmand) simulation using RSM
- error udf
- Diesel with Ammonia/Hydrogen blend combustion
- Fluent fails with Intel MPI protocol on 2 nodes
- Mass Conservation Issue in Methane Pyrolysis Shock Tube Simulation
- Script error Code: 800a000d
- Encountering Error in Heterogeneous Surface Reaction
Top Contributors-
1191
-
513
-
488
-
225
-
209
Top Rated Tags© 2024 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.
-