Failure in handling multiply connected region related to eddy curren

- March 28, 2022 at 8:57 am
  
  gyan
  Subscriber
- March 30, 2022 at 11:52 am
  
  NKC
  Forum Moderator
  
  Not sure what you are simulating exactly. But below are some suggestions based on the error message.
  Make sure all the moving objects are enclosed in the band.
  Use a segmented band instead of a cylindrical]. Create an additional dummy band object for better meshing in the airgap.
  Change the initial meh to a bit finer in the initial mesh settings.
  If this didn't work. Please share some screenshots of your model and motion setup.
  
  Regards Navya