Learning Forum

[ZGL1]

Hello all, I have been trying to get this model to converge in a simulation for quite some time. I have tried various boundary and contact conditions. I had some gap issues when I ran the contact tool's initial information, and so I modified the geometry such that the inherent gap was small enough that I would not receive the red/orange "errors" that was indicated as an issue. However, I am still unable to get the model to converge.

Note: The applied load is a rotational velocity about the z-axis (in/out of page). The two bodies are joined via a bonded connection. Ideally, I would like to change this to a frictional contact, but wanted to keep it simpler for now.

[Saumadeep Choudhury]

This is a duplicate of - Problem with convergence for a static/structural simulation ÔÇö Ansys Learning Forum
Please try to refrain from posting multiple threads for the same question.