We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Innovation Space

FREE STUDENT SOFTWARE

Mesh error after setting up composite in ACP pre

- February 6, 2022 at 5:29 pm
  
  Dioser
  Subscriber
  
  Hey everyone,
  I am using Workbench with ACP pre to set up composite material, stackups and directions for an aircraft structure, as shown in the pictures below. For reference, I used this great tutorial from YT, just adapting the methods to my problem:
  https://youtu.be/7q6ZED14Cas
- February 7, 2022 at 4:10 pm
  
  Govindan Nagappan
  Ansys Employee
  
  Check the units in ACP and also Mechanical
  Also check the units in the project schematic:
  Did you assemble meshes in Static structural system? Try using a new static structural system and send the mesh from ACP. See if it fixes the issue
  If not, your project may have corrupt data that could be causing this issue

Viewing 1 reply thread

The topic ‘Mesh error after setting up composite in ACP pre’ is closed to new replies.