Ansys Assistant will be unavailable on the Learning Forum starting January 30. An upgraded version is coming soon. We apologize for any inconvenience and appreciate your patience. Stay tuned for updates.
Ansys Products

Ansys Products

Discuss installation & licensing of our Ansys Teaching and Research products.
  1. All Channels
  2. Ansys Products
  3. THERMAL COMFORT EXTENSION EXECUTION

THERMAL COMFORT EXTENSION EXECUTION

    • November 1, 2021 at 1:48 am
      Anthonykintu
      Subscriber

      Hello.

      I am kintu Anthony.

      I am currently working on a thermal comfort analysis project for an office room in south korea.

      I installed the thermal confort extension (V1) in Ansys 2020R1 following the guidelines.

      Also, i have run the solution in fluent but when i try to execute the thermal comfort wizard, it Shows an error message "unbale to covert units() to m"

      I would like some technical advise to successfully visiaulize PPM and PPD contours.

      16357307058054059658681029561496.jpg
    • November 1, 2021 at 11:07 am
      Rob
      Forum Moderator
      Weird as neither PPM or PPD technically have proper units. Are you running an ACT or a UDF? For the former which version is it designed for?
Viewing 1 reply thread
  • The topic ‘THERMAL COMFORT EXTENSION EXECUTION’ is closed to new replies.
Innovation Space
Top Contributors

© 2026 Copyright ANSYS, Inc. All rights reserved.

Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.
[bingo_chatbox]