-
-
October 25, 2021 at 1:50 pmMichael93Subscriber
Hallo Liebe Forumsmitglieder, ich habe folgenden Fehler(Siehe Bild):
October 26, 2021 at 2:21 pmPraneethForum Moderator
Did you check whether you have sufficient RAM availability to run the simulation?
Best regards.
October 27, 2021 at 9:11 amMichael93SubscriberThis pc has 192GB RAM, but it is possible that most of it is used from other users. I have to find out where i can check the available RAM. You are sure that causes the error?
October 27, 2021 at 10:35 amPraneethForum Moderator
The issue would be with memory on your system.
Can you check whether you have enough disc space or not in the location of simulation model?
Or else you can check with a location where you have enough disc space.
All the very best.
Viewing 3 reply threads- The topic ‘error closing file %1’ is closed to new replies.
Ansys Innovation SpaceTrending discussions- HFSS Incident Plane Wave excitement mode
- Question for Maxwell
- Simulation of capacitor combining eddy currents with displacement currents
- How to calculate eddy and hysteresis losses of the core?
- Ansys Maxwell 3D – eddy current
- How to determine initial position in motion setup
- dq graph non-conformity
- How to customize pulse waveform and injection site in microstrip array
- 180 Degree Phase Shift When Measuring S21
- Simplorer+Maxwell Cosimulation results and Maxwell results mismatch
Top Contributors-
1241
-
543
-
523
-
225
-
209
Top Rated Tags© 2024 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.
-
The Ansys Learning Forum is a public forum. You are prohibited from providing (i) information that is confidential to You, your employer, or any third party, (ii) Personal Data or individually identifiable health information, (iii) any information that is U.S. Government Classified, Controlled Unclassified Information, International Traffic in Arms Regulators (ITAR) or Export Administration Regulators (EAR) controlled or otherwise have been determined by the United States Government or by a foreign government to require protection against unauthorized disclosure for reasons of national security, or (iv) topics or information restricted by the People's Republic of China data protection and privacy laws.