Learning Forum

[yu.zhu14]

Hello everyone,

After running a simulation in CFX 19.2, the following error message appeared:

Parallel run: Received message from slave

 -----------------------------------------

 Slave partition :    7

 Slave routine  : CFXMSG

 Master location : FINPAR

 Message label  : 001100288

 Message follows below - : 

 +--------------------------------------------------------------------+

 | ERROR #001100288 has occurred in subroutine CFXMSG.        |

 | Message:      

 | The following message handling error occurred: 

 | Write                            

 | Hostname:  ce-yz17014

 | Port number:  56389        

 | Messages will now be handled using a less robust method,  with a greater risk of parallel deadlocks.  

 | Note: Ensure that the hostname shown above can be resolved from all hosts used for the run.

This seems to have no influence on the results, however, when I tried to run another simulation using the results from this one as the initial condition, I encountered another error:

Parallel run: Received message from slave

 -----------------------------------------

 Slave partition :    7

 Slave routine  : ErrAction

 Master location : Message Handler

 Message label  : 001100279

 Message follows below - : 

 +--------------------------------------------------------------------+

 | ERROR #001100279 has occurred in subroutine ErrAction.       |

 | Message:                              |

 | Stopped in routine FPX: C_FPX_HANDLER   

Any ideas on what happened here?

[Surya Deb]

Hello,
Is this happening for this specific model or can you replicate this with any CFX model?
Regards SD

[yu.zhu14]

Hi SD Thanks for your reply and sorry about my late replying.
This error never shows again after I deleted a previous version of CFX V15.0 so I think it might be something related to compatibility.
In regarding your question, it was happening for all models that I tried to run.
Yours Yu