Why does the solved problem not give the stress contour plots?

- October 18, 2021 at 9:17 pm
  
  Amirmkr
  Subscriber
  
  Considering the following macro that is a static problem:
  /PREP7
  ET,1,BEAM188
  MPTEMP,,,,,,,,
  MPTEMP,1,0
  MPDATA,EX,1,,2.068e11
  MPDATA,PRXY,1,,0.3
  SECTYPE,  1, BEAM, CTUBE, , 0
  SECOFFSET, CENT
  SECDATA,0.055,0.065,4,0,0,0,0,0,0,0,0,0
  K, ,0,0,0,
  K, ,0.8,0.125,0,
  K, ,1.25,0.3,0,
  LSTR,    1,    2
  LSTR,    2,    3
  LESIZE,ALL, , ,10, ,1, , ,1,
  FLST,2,2,4,ORDE,2
  FITEM,2,1
  FITEM,2,-2
  LMESH,P51X
  FINISH
  /SOL
  ANTYPE,0
  FLST,2,1,3,ORDE,1
  FITEM,2,1
  /GO
  DK,P51X, ,0, ,0,UX,UY,UZ,ROTX,ROTY, ,
  NSEL,S, , ,   12
  DSYM,SYMM,Y, ,
  FLST,2,1,3,ORDE,1
  FITEM,2,3
  /GO
  FK,P51X,FX,-5000
  ALLSEL,ALL
  /STATUS,SOLU
  SOLVE
  
  When I want to plot the stress plots, it just gives the deformed geometry, all in red color. Why is that?
- October 19, 2021 at 8:43 am
  
  ErKo
  Ansys Employee
  
  Stress results in beam elements are typically on the cross section so we need to show that cross section in our window - to do that issue
  /ESHAPE,1
  
  Then do
  
  set,last,last
  plnsol,s,eqv ! VM stress
  
  See eshape command in help for more info.
  All the best
  
  Erik
  - October 27, 2023 at 1:57 am
    
    Chee Hui Ren
    Subscriber
    
    Hi there, for my case I managed to get a contour ribbon. However, I couldn't show any contour on my beams. Could you please advise where can I set this up?
- October 19, 2021 at 11:15 pm
  
  Amirmkr
  Subscriber
  
  Thanks a lot Erik, that solved the problem, but why does the problem in the following link not need such procedure on cross section for stress plot?
  https://www.youtube.com/watch?v=1dvEmK6To7M