Learning Forum

[Phanindra Reddy Ravi]

section.BMP

[ErKo]

Could you please put the images inline into your post since we (ansys employees) can not download them.
In any case you would need to split the geometry up where you have different shell sections.
Below is a simple example where the centre has a different section to the surrounding shell. We have two parts thus that share topology (so they are fully connected at their interface) and then we assign the different sections as shown to each of them .


Thank you

Erik

[Phanindra Reddy Ravi]

[ErKo]

In apdl you would need to define different sections, and then use esel, and emodif (SECNUM) to change the sections to what you want.

See help manual - all the best

Erik

[Phanindra Reddy Ravi]

Thank you.