We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.
Preprocessing

Preprocessing

Topics related to geometry, meshing, and CAD.
  1. All Channels
  2. Preprocessing
  3. Dimensioning discrepancies using Enclosure feature in SpaceClaim (ANSYS 2021 R1)

Dimensioning discrepancies using Enclosure feature in SpaceClaim (ANSYS 2021 R1)

TAGGED: ,

    • August 24, 2021 at 10:21 am
      dippa399
      Subscriber

      Hello,

      I have been trying to create a wind tunnel for the Ahmed Body simulation, however, there are differences between the values input along the y and z axes directions using the Enclosure feature in SpaceClaim for ANSYS 2021 R1 and the final domain size as can be observed in the image attached below and am unable to figure out this discrepancy. Can you kindly help me to resolve the same?

      Kind Regards,

      Diptesh Pawa

      Screenshot_enclosure_dimensioning_constraints.jpeg
    • August 25, 2021 at 1:02 pm
      Karthik Remella
      Administrator
      Hello What is the expected size you are looking for? And can you also share a screenshot of your inputs for the Enclosure?
      Karthik
Viewing 1 reply thread
  • The topic ‘Dimensioning discrepancies using Enclosure feature in SpaceClaim (ANSYS 2021 R1)’ is closed to new replies.
Ansys Innovation Space

© 2025 Copyright ANSYS, Inc. All rights reserved.

Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.