Add Fluent Component in Twin Builder (Simplorer)

- July 20, 2021 at 2:25 pm
  
  LuisFig
  Subscriber
  
  Hello. I am trying to make a cosimulation between Twin Builder (Simplorer) and Fluent. Basically i add a Fluent Component that has 2 outputs to the Simplorer and now I am unable to connect this outputs to the terminals of a resistor (with a wire) and the following warning shows up:
  Connection violation: A non conservative output (the Fluent output) cannot be connected to a conservative pin or net (the resistor terminals).
  Does somebody know how can I connect this 2 elements? I've tried to search in the web but I couldn't find a solution.
  
  Thank you a lot
- July 26, 2021 at 2:40 pm
  
  Karthik Remella
  Administrator
  
  Hello Could you please share a screenshot of how you are connecting these elements?
  Karthik
- July 26, 2021 at 3:37 pm
  
  LuisFig
  Subscriber
  
  Hello Karthik First of all thank you for your help.
  At this point, in order to implement my co-simulation, in the Simplorer, the Fluent component has 1 input and 1 output terminals that are connected to the terminals of a resistor (by a wire).
  I've already been able to connect the Fluent component terminals with the resistor through components called C2NC (conservative to Non-conservative), but I am not sure if this is right because when I analyze (run) the Simplorer, the following errors show up in the FLUENT:
  
  This is the screenshot of how my elements are connected:
  
  I would very much appreciate if somebody could help me. Thank you in advance.