ERROR-Solver pivot warnings or errors have been encountered during the solution. This is usually a

- July 19, 2021 at 11:22 am
  
  Amith_Anoop_Kumar
  Subscriber
- July 19, 2021 at 11:45 am
  
  ErKo
  Ansys Employee
  
  Hi
  The beam and plate are not connected, hence why it does not solve - you could see that if you apply a displacement instead of a force on the beam end (then it will show they are not connected)
  You need to have a contact bonded between the plate edge and the beam vertex in order to connect them- or use shared topology between parts.
  Erik
- July 19, 2021 at 1:18 pm
  
  Amith_Anoop_Kumar
  Subscriber
  
  Sir but doing a shared topology it didnt work out
- July 19, 2021 at 1:22 pm
  
  ErKo
  Ansys Employee
  
  Hi
  
  Just add a bonded contact in mechanical (between vertex and plate edge)- that is fine.
  
  Erik
- July 19, 2021 at 1:41 pm
  
  Amith_Anoop_Kumar
  Subscriber
  
  Sir but contact is not being applied here, there is some issue with this connection
- July 19, 2021 at 1:46 pm
  
  ErKo
  Ansys Employee
  
  Hi try have edge as target and vertex as contact.
  
  all the best
  
  Erik
- July 19, 2021 at 2:08 pm
  
  Amith_Anoop_Kumar
  Subscriber
  
  Thanks a lot Sir