How to set the maximum eigenvalue real extracted as a parameter in a modal analysis using APDL?

- July 15, 2021 at 4:18 pm
  
  Sadii045
  Subscriber
  
  I did extract stability and frequency for about 200 modes from a brake squeal analysis and I want to set the maximum stability, Number of modes, and First frequency as output parameters in Ansys. How to write the apdl command for it
- July 21, 2021 at 8:28 pm
  
  dlooman
  Ansys Employee
  
  You can use *get,,MODE,N,... as shown below for frequency and stability values. You can use *get,,active,,set,nset to retrieve the number of sets on the results file
- July 22, 2021 at 4:12 pm
  
  Sadii045
  Subscriber
  
  Thank you for the feedback. I'm quite new to ansys. I entered the following code. But I didn't get any result.
  set,list
  *get,asd1,MODE,N,STAB
  *get,asd2,active,,set,nset
  my_par1=asd1
  my_par2=asd2
  Hope you can help me out