Learning Forum

[JaeYeol]

After analyzing the beam, I checked several results. However, some parts were confirmed that were different from the predicted data.

1. I want to do an interpretation with more iterations and less convergence percentage of error. How do I change it?

2. Check the existing questions and answers, and change the iteration number in Static structure -> Commands -> NEQIT. However, the iterations checked in Solution Information -> USE PRECONDITIONED CONJUGATE GRADIENT SOLVER part are always the same as 179.

Did I check it wrong? Is there a right way?

Thanks!

[1shan]

You can change the convergence tolerance under Analysis settings>Non linear controls>force convergence "ON" and set the required tolerance. The NEQIT command should override the default 26 max iterations to a user specified value(lets say 100). You can verify this under solution information by searching for - "MAXIMUM NUMBER OF EQUILIBRIUM ITERATIONS HAS BEEN MODIFIEDTO BE, NEQIT = 100"
Regards Ishan.