About retaining data in Parameter design

- May 24, 2021 at 8:17 am
  
  Van Toan Nguyen
  Subscriber
  
  Hello everyone,
  When I used parameter set to obtain series of results. I checked the option to retain data (I think this will save all case datas). However when I saved my Workbench then opened, I set another case as current case and click "Result cell" to see detail result, there is no result and I need to update all again.
- May 24, 2021 at 11:39 am
  
  1shan
  Ansys Employee
  
  You need to update the design point before you can view the results. Have you done this? A green tick should appear once its updated.
  Regards Ishan.
- May 24, 2021 at 12:04 pm
  
  Van Toan Nguyen
  Subscriber
  
  Thank you Yes I have updated all, saved and set another case as current.