Learning Forum

[TSADEGHI]

Hello,

I am simulating spray injection in a pipe. My model is multiphase (air as a continuous phase and water liquid as a discrete phase) using K-Omega viscous model. Regarding point properties for discrete phase, I set total flow rate as 1e-5 kg/s. When I got the results, total mass in injection summary is 8.45e-8 kg. Why this happened and what should I do?

If you need more information on my model please do not hesitate.

Thanks,

Taha

[Rob]

How long has the model run for?

[TSADEGHI]

The model has run for 0.8s with time step size of 0.00015s. the whole injection process starts at 0.01s and ends at 1.51s.

[Rob]

Have any particles reported as escaped, aborted, incomplete or trapped?

[Amine Ben Hadj Ali]

You are looking in the wrong report. Please copy paste the screenshot of following command in the console /report des no yes no

[TSADEGHI]

Thank you Rob and DrAmine, I found the mass of escaped particles and it was correct,