Ansys Learning Forum › Forums › Installation and Licensing › Ansys Free Student Software › Problem Defining The Model Type (E.g. Pipe, Beam) › Reply To: Problem Defining The Model Type (E.g. Pipe, Beam)

February 8, 2021 at 6:08 am
Keyur Kanade
Ansys Employee
Duplicate of n

Hi all, me and my friends had a problem executing our stress analysis on our pipe. The reason being is because the "model type" interface under definition does not pops out (example figure below). Therefore we cannot select pipe as our model type. Can anyone help on this matter? Thanks!P/s: Our model is imported from CATIA.https://us.v-cdn.net/6032193/uploads/EVVVDJM5JI2A/whatsapp-image-2021-02-07-at-4-07-07-am-281-29.jpeg/forum/discussion/24260/problem-defining-model-type-e-g-pipe-beam-etc

n