We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › 3D Design › Why does the tolerance for the imprint tool in SpaceClaim not pick up all intersected bodies? › Reply To: Why does the tolerance for the imprint tool in SpaceClaim not pick up all intersected bodies?

August 5, 2020 at 2:31 pm
kirstenbraun
Subscriber
Below I have attached the image of what happens when I select the imprint tool. As you can see only certain edges and faces are highlighted. I would need all contacts between the various sufaces (whos topology has been shared) to imprinted onto one another, so that the mesh for the 1/17 model is exactly the same when it is rotated using the patern tool. The tolerance is set to the default of 0.1mm.nn