We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › meshing very fine only at decided area › Reply To: meshing very fine only at decided area

March 11, 2020 at 2:53 pm
Wenlong
Ansys Employee

Hi Gijoys4v,


I don't see a restriction of modeling a layered sheet.


Regarding the second question, since it is a different topic, could you please open a new thread, and provide more information, like the material properties, the model set up, numerical settings and so on. Only then can I provide meaningful suggestions other than wild guess. 


Thanks!


Regards,


Wenlong