Download the zip file and extract the contents. Go through the Instructions file. Follow along with the provided steps and solve the model. You can start the quiz after you have obtained a solution.
For performing the simulation, you can use the latest release of the academic, commercial or free student version of Ansys Mechanical. Download Ansys Student for free here.
0 of 10 Questions completed
Questions:
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading...
You must sign in or sign up to start the quiz.
You must first complete the following:
0 of 10 Questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
Unfortunately, you did not pass the quiz.
Don't be discouraged - Go through the course material including the lecture videos, handout slides, and simulation examples to prepare and try again.
Congratulations, you have passed the quiz!
You still have room for improvement - Review the slides and simulation examples again to identify the concepts that you may have missed.
Congratulations, you have passed the quiz!
You scored better than average, but if you are still unsure about a particular topic, try starting a discussion on the Ansys Learning Forum to discuss your questions with peers around the world.
Congratulations, you have passed the quiz!
You did great - Check out other courses to further your knowledge. Also, visit the Ansys Learning Forum and participate in discussions on this subject to help your peers and deepen your own knowledge.
Congratulations you have passed the quiz!
You have excelled on this topic - Check out other courses and see if you can ace them too. Also, visit the Ansys Learning Forum to help your peers on this topic. With your knowledge, you can make a real difference.
If we plot a directional deformation plot for the single node at which the striking force acts, then which of the following will be an accurate representation of the directional deformation plot obtained? Select the best option.
(A) (B)
(C)
MSUP Transient is a linear transient analysis and hence for this type of analysis, which of the following setting are set by default? Select the best option.
In the modal analysis, the total number of modes to be included is reduced to 5 from 50, then which of the following may occur? Select the best option.
The plot attached here, belongs to which of the following category? Select the best option.
The plot attached here, belongs to which of the following category? Select the 2 best options.
Without rerunning the analysis, consider a situation where we vary the damping ratio and observe how it affects the vibrational behavior of the bowl. Case-A has a damping ratio of 0.01 and Case-B has a damping ratio of 0.1. Two images are attached which show the deformation v/s time plot. Which of the following statement(s) are correct, considering the above scenario? Select the 2 best options.
Image-1
Image-2
If in the above-stated analysis, consider a case when only one mode was used then which if the following statement will hold true? Select the best option.
Without rerunning the analysis, consider a situation where we apply force in a Quasi-static manner instead of an impulse force. Which of the following statements hold true for this scenario? Select the best option.
During post-processing of the result, the deformation v/s time plot obtained is a gradually decaying waveform. One thing to note was that the waveform was not smooth, rather it had sharp corners. Which of the following can improve this situation? Select the best option.
Without rerunning the analysis, consider a situation where we change the material of the bowl from Bronze (Young’s Modulus = 1.077e+05 MPA) to Plastic (Young’s Modulus = 1700 MPA). Also attached are two vibrational responses – Plots A and B. Considering the above scenario, which of the following statement(s) hold true? Select the 2 best options.
Plot-A
Plot-B