Course Assessment — Getting Started with Geometry in Ansys Discovery
Quiz Summary
0 of 9 Questions completed
Questions:
Information
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading...
You must sign in or sign up to start the quiz.
You must first complete the following:
Results
Results
0 of 9 Questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
Categories
- Not categorized 0%
-
Unfortunately, you did not pass the quiz.
Don't be discouraged - Go through the course material including the lecture videos, handout slides, and simulation examples to prepare and try again.
-
Congratulations, you have passed the quiz!
You still have room for improvement - Review the slides and simulation examples again to identify the concepts that you may have missed.
-
Congratulations, you have passed the quiz!
You scored better than average, but if you are still unsure about a particular topic, try starting a discussion on the Ansys Learning Forum to discuss your questions with peers around the world.
-
Congratulations you have passed the quiz!
You did great - Check out other courses to further your knowledge. Also, visit the Ansys Learning Forum and participate in discussions on this subject to help your peers and deepen your own knowledge.
-
Congratulations you have passed the quiz!
You have excelled on this topic - Check out other courses and see if you can ace them too. Also, visit the Ansys Learning Forum to help your peers on this topic. With your knowledge, you can make a real difference.
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- Current
- Review
- Answered
- Correct
- Incorrect
-
Question 1 of 9
1. Question
What is the purpose of the Hex Halo and Heads-Up Display (HUD) in Discovery?
-
Question 2 of 9
2. Question
What is the purpose of the "Check Geometry Tool" in the Repair tab?
-
Question 3 of 9
3. Question
What all types of operations are possible in Pull tool? (Select all that apply)
-
Question 4 of 9
4. Question
Fill tool can be used to remove holes in the geometry. Is this statement true or false?
-
Question 5 of 9
5. Question
Pulling a line creates a
-
Question 6 of 9
6. Question
How to avoid duplicate of a component to be independent from its original component using Move tool in Ansys Discovery?
-
Question 7 of 9
7. Question
Which hotkey helps you to enter the cross-section mode by selecting face, edge or an axis?
-
Question 8 of 9
8. Question
What tool can be used to Boolean add or subtract geometries in Discovery?
-
Question 9 of 9
9. Question
How can you quickly find and select all geometry similar to a specific hole in the model?