Quiz - Fundamental Topics in Contact
Quiz Summary
0 of 10 Questions completed
Questions:
Information
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading...
You must sign in or sign up to start the quiz.
You must first complete the following:
Results
Results
0 of 10 Questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
Categories
- Not categorized 0%
-
Unfortunately, you did not pass the quiz.
Don't be discouraged - Go through the course material including the lecture videos, handout slides, and simulation examples to prepare and try again.
-
Congratulations, you have passed the quiz!
You still have room for improvement - Review the slides and simulation examples again to identify the concepts that you may have missed.
-
Congratulations, you have passed the quiz!
You scored better than average, but if you are still unsure about a particular topic, try starting a discussion on the Ansys Learning Forum to discuss your questions with peers around the world.
-
Congratulations, you have passed the quiz!
You did great - Check out other courses to further your knowledge. Also, visit the Ansys Learning Forum and participate in discussions on this subject to help your peers and deepen your own knowledge.
-
Congratulations you have passed the quiz!
You have excelled on this topic - Check out other courses and see if you can ace them too. Also, visit the Ansys Learning Forum to help your peers on this topic. With your knowledge, you can make a real difference.
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- Current
- Review
- Answered
- Correct
- Incorrect
-
Question 1 of 10
1. Question
Contact detection points cannot pass through the target face. This statement is _____.
-
Question 2 of 10
2. Question
Which of the following is NOT a rule of thumb when assigning the contact side?
-
Question 3 of 10
3. Question
Which of the following statements are correct? Pick TWO correct options.
-
Question 4 of 10
4. Question
Which of the following statements about Symmetric Contact Behavior is NOT TRUE?
-
Question 5 of 10
5. Question
Which of the following statements about an interference fit is NOT TRUE?
-
Question 6 of 10
6. Question
When modeling an interference fit, the Contact Type CANNOT be set to _____.
-
Question 7 of 10
7. Question
Which of the following conditions are necessary in order to model an interference fit correctly? Select the TWO best answers.
-
Question 8 of 10
8. Question
Which of the following statements are TRUE? Select TWO correct options.
-
Question 9 of 10
9. Question
In order to have valid results, contact penetration needs to be small as compared to _____. Select the THREE best options.
-
Question 10 of 10
10. Question
If Augmented Lagrange method is used as the contact algorithm and the obtained contact penetration is not acceptable, how can we reduce it to bring it under the allowable limit? Select THREE possible options.