Quiz: Ansys Lumerical varFDTD — Solver Physics
Quiz Summary
0 of 5 Questions completed
Questions:
Information
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading...
You must sign in or sign up to start the quiz.
You must first complete the following:
Results
Results
0 of 5 Questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
Categories
- Not categorized 0%
-
Unfortunately, you did not pass the quiz.
Don't be discouraged - Go through the course material including the lecture videos, handout slides, and simulation examples to prepare and try again.
-
Congratulations, you have passed the quiz!
You still have room for improvement - Review the slides and simulation examples again to identify the concepts that you may have missed.
-
Congratulations, you have passed the quiz!
You scored better than average, but if you are still unsure about a particular topic, try starting a discussion on the Ansys Learning Forum to discuss your questions with peers around the world.
-
Congratulations, you have passed the quiz!
You did great - Check out other courses to further your knowledge. Also, visit the Ansys Learning Forum and participate in discussions on this subject to help your peers and deepen your own knowledge.
-
Congratulations you have passed the quiz!
You have excelled on this topic - Check out other courses and see if you can ace them too. Also, visit the Ansys Learning Forum to help your peers on this topic. With your knowledge, you can make a real difference.
- 1
- 2
- 3
- 4
- 5
- Current
- Review
- Answered
- Correct
- Incorrect
-
Question 1 of 5
1. Question
Arrange the following steps of the simulation workflow in the correct order.
-
Set up structures
-
Select slab mode
-
View monitor results
-
Select source mode
-
Run simulation
View Answers:
CorrectIncorrect -
-
Question 2 of 5
2. Question
Which of the following settings will have an effect on the calculated effective 2D slab material which is used in the varFDTD simulation?
CorrectIncorrect -
Question 3 of 5
3. Question
Consider the differences between traditional 2D FDTD simulations and varFDTD simulations in MODE. Which of the following statements are true?
CorrectIncorrect -
Question 4 of 5
4. Question
Which of the following are assumptions of the effective index calculation?
CorrectIncorrect -
Question 5 of 5
5. Question
The following image shows the XY view of a silicon-on-insulator MMI coupler structure. Where on the image would you place the indicator (green cross) for slab mode to properly simulate this structure?
CorrectIncorrect