We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Innovation Space

FREE STUDENT SOFTWARE

Design of a rectangular to circular hopper

- April 1, 2025 at 12:56 pm
  
  smani
  Subscriber
  
  Hi everyone,
  I want to design a rectangular to circular hopper i.e. transition from a rectangular surface to circular surface in HFSS.
  I am trying but not getting the exact transition. Any suggestions or help would be great.
  Also, thanks in advance.
- April 1, 2025 at 6:59 pm
  
  Gia
  Ansys Employee
  
  There is not a built-in function to create this type of geometry.
  I would reccomend to create a single 2D surface that can be wrapped around a 3D cylinder.
  Calculate the flat form for Rectangular to Round duct transition | SolidWorks Share: https://www.youtube.com/watch?v=UE-WfxCkUfU
  The 2D Surface can first be created using the command [Draw > Equation Based Surface...]
  The Wrap Sheet command can be found [Modeler > Surface > Wrap Sheet]

Viewing 1 reply thread

You must be logged in to reply to this topic.

Ansys Assistant

Hey there, you are quite inquisitive!
You have hit your hourly question limit.
Please retry after '10' minutes.
For questions, please reach out to ansyslearn@ansys.com.

RETRY