Please note that you only have 5 attempts to pass this Quiz.
0 of 8 Questions completed
Questions:
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading...
You must sign in or sign up to start the quiz.
You must first complete the following:
0 of 8 Questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
Unfortunately, you did not pass the quiz.
Don't be discouraged - Go through the course material including the lecture videos, handout slides, and simulation examples to prepare and try again.
Congratulations, you have passed the quiz!
You still have room for improvement - Review the slides and simulation examples again to identify the concepts that you may have missed.
Congratulations, you have passed the quiz!
You scored better than average, but if you are still unsure about a particular topic, try starting a discussion on the Ansys Learning Forum to discuss your questions with peers around the world.
Congratulations, you have passed the quiz!
You did great - Check out other courses to further your knowledge. Also, visit the Ansys Learning Forum and participate in discussions on this subject to help your peers and deepen your own knowledge.
Congratulations you have passed the quiz!
You have excelled on this topic - Check out other courses and see if you can ace them too. Also, visit the Ansys Learning Forum to help your peers on this topic. With your knowledge, you can make a real difference.
Why should components that produce sharp bends in rays be avoided in design?
Why should very thin components be avoided in design?
What is meant by element coupling in assembly?
What is the centering of a lens?
Why should weak radii of curvature be avoided in design?
What are Monte Carlo simulations used for in design?
Zernike polynomials are __________.
What is the recommended minimum thickness to diameter ratio for lenses in hand held optics?