{"id":365395,"date":"2024-05-03T12:00:37","date_gmt":"2024-05-03T12:00:37","guid":{"rendered":"\/forum\/forums\/topic\/simplorer-link-to-maxwell-transient\/"},"modified":"2024-05-03T12:00:37","modified_gmt":"2024-05-03T12:00:37","slug":"simplorer-link-to-maxwell-transient","status":"closed","type":"topic","link":"https:\/\/innovationspace.ansys.com\/forum\/forums\/topic\/simplorer-link-to-maxwell-transient\/","title":{"rendered":"Simplorer link to Maxwell transient"},"content":{"rendered":"

Hello, I’m building a voltage based simulation of a PMSM. for this purpose i build a very basic circuit in Simplorer and a basic fem geometry for the Maxwell 2D transient analysis, where I set “external” to the three windings.
When I insert the Maxwell component into the Simplorer circuit the software needs of course the three phases. Then it also needs:
1) “MotionSetup1_in” which i guess it is the stator position that I’ll connect to the ground
2) “MotionSetup1_out” this i don’t understand. The simulation I’m willing to do here is transient yes, but I’ll use a fixed speed, as the inverter is fed with sine wave of constant frequency, so what should i provide at that interface? I don’t think any mechanical mass information is needed, as ,theoretically, moment of inertia and similar things are not required as there is not change in speed.<\/p>\n

 <\/p>\n

thanks a lot to anyone which is able to explain the meaning of those two additional interfaces<\/p>\n

<\/p>\n","protected":false},"template":"","class_list":["post-365395","topic","type-topic","status-closed","hentry","topic-tag-Qfactor-1"],"aioseo_notices":[],"aioseo_head":"\n\t\t\n\t\n\t\n\t\n\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t