{"id":317430,"date":"2023-11-15T08:35:01","date_gmt":"2023-11-15T08:35:01","guid":{"rendered":"\/forum\/?post_type=topic&p=317430"},"modified":"2023-11-15T08:35:01","modified_gmt":"2023-11-15T08:35:01","slug":"what-steps-should-i-take-to-set-up-a-wave-height-meter-in-fluent","status":"closed","type":"topic","link":"https:\/\/innovationspace.ansys.com\/forum\/forums\/topic\/what-steps-should-i-take-to-set-up-a-wave-height-meter-in-fluent\/","title":{"rendered":"What steps should I take to set up a wave height meter in Fluent?"},"content":{"rendered":"

Hello everyone,<\/span><\/p>\n

I want to use the Fluent Setup section to set up a wave height meter to measure the water level in each cabin.<\/span><\/p>\n

The picture below is a cross-section of my boat.<\/span><\/p>\n

<\/span><\/p>\n

 <\/p>\n

The DB2 cabin will be flooded by water.<\/span><\/p>\n

Before water enters the cabin, it is filled with air.<\/span><\/p>\n

The steps of the method I currently use are as follows:<\/span><\/p>\n

Setp1.After entering Setup, I created an Iso-surface in the cabin of DB1.<\/span><\/p>\n

<\/span><\/p>\n

Setp2.On top of the Iso-surface I already created, I made another Iso-surface.<\/span><\/p>\n

<\/span><\/p>\n

Setp3.I create an Iso-clip on the Iso-surface in the z-Coordinate.(The phase needs to be changed to water. Min=0.5~Max=1)<\/span><\/p>\n

<\/span><\/p>\n

The method I used did not record the water level changes in the report.<\/span><\/p>\n

Can you suggest any other ways to resolve this problem?<\/p>\n

Thanks????<\/p>\n","protected":false},"template":"","class_list":["post-317430","topic","type-topic","status-closed","hentry","topic-tag-2022-r1-1","topic-tag-ansys","topic-tag-fluent"],"aioseo_notices":[],"aioseo_head":"\n\t\t\n\t\n\t\n\t\n\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t