{"id":302865,"date":"2023-08-23T07:59:02","date_gmt":"2023-08-23T07:59:02","guid":{"rendered":"\/forum\/forums\/topic\/magneto-resistive-sensor-for-gear-tooth-sensing\/"},"modified":"2023-08-23T07:59:02","modified_gmt":"2023-08-23T07:59:02","slug":"magneto-resistive-sensor-for-gear-tooth-sensing","status":"closed","type":"topic","link":"https:\/\/innovationspace.ansys.com\/forum\/forums\/topic\/magneto-resistive-sensor-for-gear-tooth-sensing\/","title":{"rendered":"Magneto-resistive sensor for gear tooth sensing"},"content":{"rendered":"

Dear users.<\/p>\n

I am trying to simulate an assembly of a magneto-resistive sensor (AMR) with a bladedd disk in order to have an overview on position sensing measurement where I would like to plot the Voltage output of the sensor when the blades pass under it.<\/p>\n

I was successful in following the exmaple in ANSYS maxwell so far, but they do not show how to extract the voltage in this case ( most of the example stop in the extraction the magnetic induction versus the angle ).<\/p>\n

my IC is simple resistor bridge. input voltage is 5 volts.<\/p>\n

my 2nd question is on how to control the rotation speed of the disk? I would like to change the speed and control the acceleration in the same time.<\/p>\n

\"\"<\/p>\n

Thank you in advance<\/p>\n","protected":false},"template":"","class_list":["post-302865","topic","type-topic","status-closed","hentry","topic-tag-AnsysMaxwellelectronics-1","topic-tag-ansys-electronics-desktop","topic-tag-sensor-1","topic-tag-transient"],"aioseo_notices":[],"aioseo_head":"\n\t\t\n\t\n\t\n\t\n\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t