{"id":386657,"date":"2024-09-24T16:40:38","date_gmt":"2024-09-24T16:40:38","guid":{"rendered":"https:\/\/innovationspace.ansys.com\/forum\/forums\/reply\/386657\/"},"modified":"2024-09-24T16:40:38","modified_gmt":"2024-09-24T16:40:38","slug":"386657","status":"publish","type":"reply","link":"https:\/\/innovationspace.ansys.com\/forum\/forums\/reply\/386657\/","title":{"rendered":"Reply To: SMART crack under fatigue conditions, different crack sizes can’t growth"},"content":{"rendered":"

<p>Hello,<\/p><p>When the crack extension increment, delta_a, is calculated using the cycle by cycle method, it is expected to be relatively close to the element size along the crack front (the default maximum delta_a increment, damax, is set to 1.5*element_size). If the calculated delta_a is greater than damax, then the program will automatically scale both delta_a and delta_N (these will be a new delta_a and delta_N values for the next sub step), to be closer to the damax value. (For reference see section 3.3.1.11. Specifying the Crack-Growth Increments in a Step in the MAPDL Fracture Analysis Guide)<\/p><p>Since the solver is reporting a single number of cycles in the error message, this may indicate that the program is significantly scaling down delta_a and delta_N due to the calculated delta_a value widely overshooting damax. The issue is that this doesn’t adhere to the assumptions of stable fatigue crack growth, as mediated by the Paris’ Law parameters, hence the message about aborting the crack growth portion of the solve.<\/p><p>To achieve a more reasonable result, there are a number of inputs which can be adjusted such as adjusting the mesh size along the crack front, adjusting the damax parameter, and\/or adjusting the boundary condition loading. To lend a bit more precision to your choice, consider doing a manual calculation of delta_a using the program-calculated SIF value without specifying crack growth. e.g., suppress the SMART crack growth object and run a simulation with your current loading. Take the max SIF value and use that to calculate delta_a at a given node using the following formula: <\/p><p>delta_a_at_node_i = delta_N*(delta_a\/delta_N)_at_node_i<\/p><p>where delta_N = 100 cycles and (delta_a\/delta_N)_at_node_i = C*delta_K^m (K can be taken from a given node along the crack front). This will reveal how close the initial calculated delta_a value is to damax (which can be calculated as 1.5*element_size along the crack front at node i). Based on this, you can adjust either of the aforementioned inputs and re-run the fatigue crack growth simulation to see if the calculation make more sense.<\/p><\/p>\n","protected":false},"template":"","class_list":["post-386657","reply","type-reply","status-publish","hentry"],"aioseo_notices":[],"aioseo_head":"\n\t\t\n\t\n\t\n\t\n\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t