{"id":355945,"date":"2024-03-07T17:29:03","date_gmt":"2024-03-07T17:29:03","guid":{"rendered":"\/forum\/forums\/reply\/355945\/"},"modified":"2024-03-07T17:30:33","modified_gmt":"2024-03-07T17:30:33","slug":"355945","status":"publish","type":"reply","link":"https:\/\/innovationspace.ansys.com\/forum\/forums\/reply\/355945\/","title":{"rendered":"Reply To: USING ANSYS FORTE"},"content":{"rendered":"

<p> <\/p><p>Hi Favour:<\/p><p>Below are the answers to your questions:<\/p><div>1) The only limitation listed for the student version of Forte is the mesh size, which is limited to 1 million for fluids products.  Here is an informational link to the student offering:<\/div><div> <\/div><div>https:\/\/www.ansys.com\/academic\/students\/ansys-student<\/div><div> <\/div><div>2) <span tabindex=””0″” role=””button”” aria-label=””Opens” data-lpc-hover-target-id=””lpc-react-target-30″” aria-haspopup=””dialog”” data-is-focusable=””true””>I am still looking into the answer for this question.  Normally the fuel can be modified to include various components, but this is done to create a surrogate blend that simulates the fuel in the reaction mechanism. It may therefore be necessary to create a different mechanism for each composition.<br><\/span><\/div><div> <\/div><div>3) The compression ratio can be adjusted in different ways without requiring new CAD geometry, depending on what really happens in the engine hardware. Here are a few typical scenarios:<\/div><div> <\/div><div>1) Adjust the stroke value on the piston boundary condition panel;<\/div><div>2) Adjust the squish height by moving the piston in the imported surface mesh;<\/div><div>3) If the engine contains a volume representing the crevice region, adjust the height of the crevice region.<\/div><div> <\/div><div>The “Compression Ratio Calculator” described in section 2.8.15 of Forte User’s Guide can be used to check the CR value during the setup stage.<\/div><div> <\/div><div>Best Regards,<\/div><div> <\/div><div>Judy<\/div><p> <\/p><\/p>\n","protected":false},"template":"","class_list":["post-355945","reply","type-reply","status-publish","hentry"],"aioseo_notices":[],"aioseo_head":"\n\t\t\n\t\n\t\n\t\n\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t