We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.
General Mechanical

General Mechanical

Topics related to Mechanical Enterprise, Motion, Additive Print and more.
  1. All Channels
  2. General Mechanical
  3. thermal analysis over a shell

thermal analysis over a shell

TAGGED: ,

    • April 1, 2024 at 7:19 am
      naganathan ravi
      Subscriber

      i am trying to estimate the critical buckling temperature of the FGM shell, in which i have created various size of cutouts. and my problem is i have to apply temperature in both top area and bottom area but i have only one area because through shell sections i have varied the material properties. so how to apply temperature and the critical buckling temperature results i am getting right now are not decreasing as cutout size increases. can you kindly  help how to do this

    • April 2, 2024 at 4:18 am
      Sampat Kumar
      Ansys Employee

       

      Hi 
      please follow the following link.


      Best Regards,
      Sampat

       

       

Viewing 1 reply thread
  • The topic ‘thermal analysis over a shell’ is closed to new replies.
Ansys Innovation Space

© 2025 Copyright ANSYS, Inc. All rights reserved.

Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.