We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › Electronics › Can’t run electromagnetics in AIM › Reply To: Can’t run electromagnetics in AIM

October 3, 2017 at 7:13 pm
hollansk
Subscriber

I too am having the same challenges developing an electromagnetics simulation. I was hopeful to have students use AIM to visualize fields.


I set up a simple two magnet geometry. Immediately after importing the geometry, I receive the "Physics Region Warning" and "Selected Physics Type is not valid" message. No further options. I have tried a clean reinstall and all of the tricks above. Any progress on this issue?


Would it be better to switch to the ANSYS Student instead of AIM? Just concerned about learning curve for students... but working is better than not, I suppose!