We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › About geometry ovelapping › Reply To: About geometry ovelapping

December 13, 2024 at 7:58 pm
peteroznewman
Subscriber

It looks like the contact definition only selected the flat top of the body and did not include the blends on the corners or the sides.  Or if the blends were included, the Pinball Radius was too small and did not pick up all the nodes around the corner.