We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Fluids › UNASSIGNED INTERFACE ZONE DETECTED FOR INTERFACE… › Reply To: UNASSIGNED INTERFACE ZONE DETECTED FOR INTERFACE…

December 2, 2024 at 1:04 pm
aagalvez
Subscriber

 

Hi. Thank you for your reply. I tried to make the symmetry as a wall boundary type in the ansys solution then tried to slit these face zones thru the console. Then I classified these zones into interfaces. After that, I manually created mesh interfaces. I already solved my problem. 

Â