We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Photonics › How to get rid of slab modes in EME solver › Reply To: How to get rid of slab modes in EME solver

November 28, 2024 at 3:41 pm
taynara.deoliveira
Subscriber

Hi,

It is correct. The strucure group is rotated. 

I think is indeed related to the mesh. I will try what you suggested

But now i am facing another problem. I don't know why i often receive this error: Meshing complete in 0.093750 seconds of CPU time
Error: Port mode set for port '::model::EME::Ports::port_1' could not be found or updated.

It says that the port could not be updated, And the Port is there... I changed from left to right, but i suppose this is allowed and should not be a problem. And the autoupdates is selected

Do you know what it can be? 

Thank you.