We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum Forums Discuss Simulation Fluids A problem of auto-mesh in ANSYS FORTE Reply To: A problem of auto-mesh in ANSYS FORTE

jcooper
Ansys Employee

Hi:

This troubleshooting page, available in the ANSYS Forte Best Practices PDF, may be helpful for future issues.  

https://ansyshelp.ansys.com/account/secured?returnurl=/Views/Secured/corp/v242/en/forte_bp/ch03s02.html

The inverted surface normals issue is mentioned there, but it should not be coming up in a tutorial without warning.