We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Fluids › BAD TERMINATION in Fluent when apply profile data to boundary › Reply To: BAD TERMINATION in Fluent when apply profile data to boundary

November 1, 2024 at 8:19 am
Dato
Subscriber

I'm sure that the specified x and y coordinate is correctly located on the left inlet boundary. 

So I'm confused by the strange previewed point cloud.Â