We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › How to create a Shared Topology? › Reply To: How to create a Shared Topology?

October 30, 2024 at 11:30 am
Erik Kostson
Ansys Employee

 

Hi

See here how to use share topology – alternatively one can also instead use bonded contacts.

https://www.youtube.com/watch?v=aqAYnZXoUHQ

Also which course is this (paste the link)

All the best

 

Erik

Â