We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Stress Display for Top/Bottom is Not Matching with Individual ‘Top’ Surface › Reply To: Stress Display for Top/Bottom is Not Matching with Individual ‘Top’ Surface

October 27, 2024 at 4:43 pm
choo.fuhsien
Subscriber

Thank for the quick response sir.

Under Element Mean, there is no option for Average Across Bodies. I have separately scoped the top surface for the area with maximum Element Mean stress and the 'Top/Bottom' stress is still lower than the 'Top' stress. Does this mean that the 'Top/Bottom' is unable to capture the maximum stress and I need to check 'Top' and 'Bottom' just to be safe?Â