We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › 3D Design › Parametric circular pattern › Reply To: Parametric circular pattern

October 25, 2024 at 10:37 am
Devendra Badgujar
Forum Moderator

Hello Antonio, 

Yes, this is also a one of the approach of doing this. The parameters tab will be available once you have created the pattern:

Regards,

DevendraÂ