Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › How to get deformation angle in Ansys Mechanical (Transient structural) › Reply To: How to get deformation angle in Ansys Mechanical (Transient structural)
October 24, 2024 at 12:18 pm
tayyaba.bano
Subscriber
Thank you but I tried that by selecting a face also and it gives me the same information about the result file, I guess I did not set all output controls on i.e. Nodal forces. I have run so far my simulations till 5sec, can I change the setting or define a remote point at 5sec and run it further? does this work?