We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Electronics › Issue with Fluctuating Moving Torque in ANSYS Maxwell 2D transient Simulation › Reply To: Issue with Fluctuating Moving Torque in ANSYS Maxwell 2D transient Simulation

October 22, 2024 at 3:40 pm
GLUO
Ansys Employee

You are using uncontrolled current source and constant speed. In this case you need to adjust initial rotor angle or phase of current to adjust the torque.