We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum Forums Discuss Simulation General Mechanical Simulation not able to converge Reply To: Simulation not able to converge

harshvardhan.negi
Ansys Employee

Hi,
There can be many reasons the solution to not converge. The best option to look for a specific issue is to check the Solver Output and see what error message is present there and what steps has the solver been doing before it.

The solver output can be found in the Solution Information tab under the Solution tree.

Regards,
Harshvardhan
Ansys Help
Ansys Learning Forum (Rules & Guidelines)