We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Electronics › How to determine initial position in motion setup › Reply To: How to determine initial position in motion setup

October 16, 2024 at 5:43 pm
uchechi.innocent
Subscriber

Hi Ivonne,

Thank you for replying. 

Please, this is the first time I am designing electrical machines without using a user-defined primitive or template. I am designing a Surface-mounted permanent magnet using 2D Maxwell and have watched many videos on rotating machine design but have not seen where a detailed calculation and the determination of the initial position in motion setup are fully discussed during design.

I am still at the level of getting a positive valve of an average moving torque with time.

Below is my moving torque graph after simulation.

Thank you.